Types of Ethernet Cable – CCNA Course

0
12
types of Ethernet Cable

An Ethernet Cable is one of the commonly used network cables that connect hardware in the local area network and we are going to discuss its types under our CCNA Course.

If you want to know what are the types of Network, then you can click here.

The cable that is used to make an Ethernet cable contains different color wires and they are arranged in different ways to make different types of Ethernet cables.

Ethernet cabling

Ethernet cabling is an important discussion, especially if you are planning on taking the Cisco exams. Three types of Ethernet cables are available:

  • Straight-through cable
  • Crossover cable
  • Rolled cable

We will look at each in the following sections.

Straight-through cable

The straight-through cable is used to connect

  • Host to switch of hub
  • Router to switch or hub

Four wires are used in a straight-through cable to connect Ethernet devices. It is relatively simple to create this type. The following figure shows the four wires used in a straight-through Ethernet cable.

Notice that only pins 1, 2, 3, and 6 are used. Just connect 1 to 1, 2 to 2, 3 to 3, and 6 to 6 and you’ll be up and networking in no time. However, remember that this would be an Ethernet-only cable and wouldn’t work with voice, Token ring, ISDN, and so on.

Types of Ethernet Cable - CCNA Course

Crossover cable

The crossover cable can be used to connect

  • Switch to switch
  • Hub to hub
  • Host to host
  • Hub to switch
  • Router direct to host

The same four wires are used in this cable as in the straight-through cable; we just connect different pins together. The following figure shows how the four wires are used in a crossover Ethernet cable.

Notice that instead of connecting 1 to 1, 2 to 2, and so on; here we connect pins 1 to 3 and 2 to 6 on each side of the cable.

Types of Ethernet Cable - CCNA Course

Rolled cable

Although rolled cable isn’t used to connect any Ethernet connections together, you can use a rolled Ethernet cable to connect a host to a router console serial communications (com) port.

If you have a Cisco router or switch, you would use this cable to connect your PC running Hyper Terminal to the Cisco hardware. Eight wires are used in this cable to connect serial devices, although not all eight are used to send information, just as in Ethernet networking. The image below shows the eight wires used in a rolled cable.

Types of Ethernet Cable - CCNA Course

These are probably the easiest cables to make because you just cut the end off on one side of a straight-through cable, turn it over, and put it back on (with a new connector, of course).

Once you have the correct cable connected from your PC to the Cisco router or switch, you can start Hyper Terminal to create a console connection and configure the device. Set the configuration as follows:

  1. Open Hyper Terminal and enter a name for the connection. It is irrelevant what you name it, but I always use Cisco. Then click OK.
  2. Choose the communication port either COM1 or COM2, whichever is open on your PC.
  3. Now set the port settings. The default values (2400bps and no flow control hardware) will not work; you must set the port correctly.

Notice that the bit rate is now set to 9600 and the flow control is set to none. At this point, you can click OK and press the Enter key and you should be connected to your Cisco device console port.

For the connection between the switches, we’d obviously use a crossover cable as we saw in the above image. The trouble is, we have a console connection that uses a rolled cable.

Plus, the connection from the router to the switch is a straight-through cable, as is true for the hosts to the switches. Keep in mind that if we had a serial connection (which we don’t), it would be a V.35 that we’d use to connect us to a WAN.